Copper Domestic Water Side Arm Heat Exchanger

READ BELOW TO FIND OUT WHY THIS SIDE ARM IS THE BEST ON THE MARKET!!!

Many sidearms have a tube within a tube only, these sidearms have multiple tubes within the exterior tube. By having the greatest amount of surface area it makes our sidearm the most efficient on the market.  MORE SURFACE AREA = MORE EFFICIENT = MORE HOT WATER & QUICKER RESPONSE TIMES  Most sellers use just a normal piece of 3/4" copper shoved down the center, OR they use a roll threaded type tube.

Our sidearm has a 1-1/2" outer tube and is 13" long, this allows for a much easier installation between your hot water tank drain and the pressure relief valve.  Overall the sidearm measures 17-1/4" long from end to end.  Because of the internal tube design you've actually got much more surface area than a traditional 48" sidearm.  The problem with long sidearms is that 99% of the time you have to plumb from the top of the sidearm down so far to the pressure relief valve that you lose the efficiency of the thermal syphon.  In a long sidearm like that the hot water rises in the sidearm as it is heated but the hot water does not easily drop down and back into the tank because hot water rises and cold water sinks.  If you have used the larger sidearms before you know exactly what I'm talking about. 

Our side arms are packaged the best possible way to minimize shipping damage.  The side arms fit snuggly in the boxes to minimize movement within the box.  The ports are surrounded in styrofoam all the way around to prevent damage if dropped. The entire side arm is packaged in a double wall, re-enforced cardboard box and taped closed.

We do our best to offer a high quality product that will not be damaged during shipping and you will not have to return due to manufacturers defects such as leaking.  We stand behind the exchangers with a LIMITED LIFETIME WARRANTY AGAINST MANUFACTURERS DEFECTS.  A free copy of the written warranty is available upon request to our email address.

TESTING DATA:
50 Degree domestic water entering
130 Degree domestic water leaving
2.1 GPM through domestic side
8.5 GPM through furnace side
160 degree boiler water entering

- using these above parameters, this sidearm produces 84,000 BTU
- recovery time for a 50 gallon water heater is 15 MINUTES

- Comes FULLY ASSEMLBED/PRE-SOLDERED and ready to install.  PRESSURE TESTED to ensure a leak free unit. 

- 1-1/2" copper on the outside w/ 1" copper sweat connections for the boiler input/output, 1-1/2" outside shell produces maximum efficiency with minimal pressure drop on boiler side
- 3/4" sweat connections for the domestic water input/output
- Will work with ANY existing gas/oil/propane/electric hot water tank heater 
- This is also available in a Threaded/FPT model