Availability: Out of stock
Copper Domestic Water Side Arm Heat Exchanger
Our sidearm has a 1-1/2" outer tube and is 13" long, this allows for a much easier installation between your hot water tank drain and the pressure relief valve. Overall the sidearm measures 17-1/4" long from end to end. Because of the internal tube design you've actually got much more surface area than a traditional 48" sidearm. The problem with long sidearms is that 99% of the time you have to plumb from the top of the sidearm down so far to the pressure relief valve that you lose the efficiency of the thermal syphon.
Our side arms are packaged the best possible way to minimize shipping damage. The side arms fit snuggly in the boxes to minimize movement within the box. The ports are surrounded in styrofoam all the way around to prevent damage if dropped. The entire side arm is packaged in a double wall, re-enforced cardboard box and taped closed.
We do our best to offer a high quality product that will not be damaged during shipping and you will not have to return due to manufacturers defects such as leaking. We stand behind the exchangers with a LIMITED LIFETIME WARRANTY AGAINST MANUFACTURERS DEFECTS.
TESTING DATA: 50 Degree domestic water entering 130 Degree domestic water leaving 2.1 GPM through domestic side 8.5 GPM through furnace side 160 degree boiler water entering
- using these above parameters, this sidearm produces 84,000 BTU - recovery time for a 50 gallon water heater is 15 MINUTES
Comes FULLY ASSEMLBED/PRE-SOLDERED and ready to install. PRESSURE TESTED to ensure a leak free unit.
1-1/2" copper on the outside w/ 1" FPT connections for the boiler input/output, 1-1/2" outside shell produces maximum efficiency with minimal pressure drop on boiler side. 3/4" FPT connections for the domestic water input/output - Will work with ANY existing gas/oil/propane/electric hot water tank heater.